Ametek SFA Series Ethernet Programming User Manual download pdf (Page 130)

SCPI Command Operation SG Series Programming

6-58 M550129-03 Rev K

To stop the execution of the square wave sequence, issue the STOP

state command:

PROG:STAT STOP

The sequence should stop running while the unit remains at the state of

the last command within the sequence.

To pause instead of stop, issue the PAUSE state command instead:

PROG:STAT PAUSE

After pausing, the output will remain at its present value.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 158 159

SG Series IEEE 1
488.2/RS232 and 1
Ethernet Options 1
CONTENTS 12
OVERVIEW 19
M550129-03 Rev 20
IEEE 488.2 GPIB/RS232 21
FEATURES, FUNCTIONS 21
AND SPECIFICATIONS 21
READBACK FUNCTIONS 22
SPECIFICATIONS 22
IEEE 488.2 GPIB/ RS232 23
CONFIGURATIONS 23
AND REMOTE PROGRAMMING 23
RS232 SETUP PROCEDURE 25
Configuration Switch 27
Remote/Local Selection 28
Shield Ground 30
Address Selection 30
REMOTE PROGRAMMING VIA RS232 31
ETHERNET INTERFACE 33
FEATURES, FUNCTIONS AND 33
FEATURES AND FUNCTIONS 34
Programming Resolution 36
Programming Accuracy 36
Readback Resolution 36
Readback Accuracy 37
ETHERNET CONFIGURATION 41
AND REMOTE PROGRAMMING 41
ETHERNET SETUP PROCEDURE 43
Network Setup Using DHCP 44
Network Setup Using Auto-IP 45
EXTERNAL USER CONTROL SIGNAL 50
CONNECTOR 50
ETHERNET 53
ETHERNET WEB PAGES, OVERVIEW 54
Figure 5-11. Login Window 55
CONFIGURATION 56
IP CONFIGURATION 57
SETTINGS 61
PRESETS 68
SECURITY 70
EXISTING 72
AND SCPI COMMAND OPERATION 73
Register 75
Registers 77
Error/Event Queue 77
CONFORMANCE INFORMATION 80
Conventions 81
Queries 81
IEEE 488.2 COMMON COMMAND 82
SUBSYSTEM 82
SOURCE SCPI Command Summary 84
RAMP FUNCTION 88
MEASURE SCPI Command Summary 89
OUTPUT SCPI Command Summary 90
STATUS SCPI Command Summary 91
SYSTEM SCPI Command Summary 93
TRIGGER SCPI Command Summary 98
(applies to Ethernet only) 100
SGI-UNIQUE COMMANDS 104
M550129-03 Rev K 105
EFERENCE 108
VI Mode Example 115
OVP Setup Example 115
Trigger Example 116
Hardware Trigger Example 117
Ramp V Example 117
Ramp I Example 117
Ramp V Example 2 118
Power On INIT Example 118
“Charge” 128
“Discharge” 128
CALIBRATION 135
SETUP FOR CALIBRATION 136
(ETHERNET) 137
(ETHERNET, GPIB) 139
CALIBRATION (ETHERNET, GPIB) 140
CAL:OUTP:CURR:CALC 144
ANALOG PROGRAM ADJUSTMENT 145
Adjustment for Current Mode 148
Adjustment for Voltage Mode 149
SCPI STATUS IMPLEMENTATION 153

Comments to this Manuals

No comments

Ametek SFA Series Ethernet Programming User Manual Page 130

Comments to this Manuals

Related products and manuals for Equipment Ametek SFA Series Ethernet Programming